Soldering an EMG HZ in with 2 single coils... HELP?!?!

Discussion in 'Tech-Talk' started by ZILF, Jul 10, 2017.

  1. ZILF

    ZILF New Member!

    Age:
    30
    Messages:
    1
    Joined:
    Jul 10, 2017
    Location:
    England
    Hey there ladies and gentlemen! Im new to the group and new to soldering and apparently this is the place to seek some solid advice. I am hoping to solder in an EMG HZ into the bridge position of my project strat guitar, with a single coil in the neck and middle position. I have a 5-Pin solderless thats open on the other end. Once iv done this i also need to re solder the input jack and the grounds. Iv practiced a little bit with the soldering and am ready to get it all together again, so my question to you all is this...

    Please can somebody best explain which wire needs to be soldered where in order for it to work??

     

    Attached Files:

  2. stratman in va

    stratman in va Most Honored Senior Member

    Age:
    52
    Messages:
    8,830
    Joined:
    Jul 27, 2012
    Location:
    Virginia
    You should be able to get a diagram online from EMG for that.

    Each coil will have 2 wires, and there will also be a ground/bare wire that goes to ground aka earth.